April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Position Sensor

WARNING: This page is about a different variant/trim than selected.

Reconnect all harness connectors disconnected.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Turn ignition switch ON.
Set selector lever to D position (A/T models) or 1st position (M/T models).
Check voltage between ECM terminals 83 (TP sensor 1 signal), 84 (TP sensor 2signal) and ground under the following conditions.

Fig 1: Terminal Voltage Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Voltage Between Terminals 83, 84 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.
If NG, replace electric throttle control actuator and go to the next step.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
Perform "IDLE AIR VOLUME LEARNING ".