DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT-II
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
- Start engine and wait at least 40 seconds.NOTE: Do not depress accelerator pedal even slightly.
If 1st trip DTC is detected, go to Diagnostic Procedure .
WITH GST
Follow the procedure "WITH CONSULT-II" above.