Overall Function Check
Use this procedure to check the overall function of the A/F sensor 1 circuit. During this check, a DTC might not be confirmed.
WITH GST
- Start engine and warm it up to normal operating temperature.
- Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
- Set 5th position, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).NOTE: Never apply brake during releasing the accelerator pedal.
- Repeat steps 2 to 3 five times.
- Stop the vehicle and turn ignition switch OFF.
- Wait at least 10 seconds and restart engine.
- Repeat steps 2 to 3 five times.
- Stop the vehicle and connect GST to the vehicle.
- Make sure that no DTC is displayed.
If the DTC is displayed, go to Diagnostic Procedure .