With CONSULT-II

Start engine (TCS switch or VDC switch OFF).
Select "DATA MONITOR" mode with CONSULT-II.
Drive the vehicle for at least 5 consecutive seconds under the following condition.

Fig 1: Test Parameters
Courtesy of NISSAN MOTOR CO., U.S.A.

If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

If DTC is not detected, go to the following step.
Drive the vehicle for at least 5 consecutive seconds under the following condition.

Fig 2: Drive The Vehicle For At Least 5 Consecutive Seconds Under The Following Condition
Courtesy of NISSAN MOTOR CO., U.S.A.
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".