6. Check Electronic Controlled Engine Mount Output Signal Circuit For Open And Short

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check harness continuity between ECM terminals and electronic engine mount terminals as follows. Refer to Wiring Diagram.
   Fig 1: Check Harness Continuity Between ECM Terminals And Electronic Engine Mount Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.
   1. Continuity should exist. 
4. Also check harness for short to ground and short to power.

OK or NG 

1. OK : GO TO 7.
2. NG : Repair open circuit or short to ground or short to power in harness or connectors.