Without CONSULT-II

1. Start engine and warm it up to normal operating temperature.
2. Disconnect front electronic controlled engine mount harness connector when engine speed is more than 1,000 rpm.
3. When returning engine speed to idle speed, check that body vibration increases compared with the condition of the above step 1 (with vehicle stopped).

   If the vibration is not changed, go to next step.

4. Check that the motor operating sound is heard from front electronic controlled engine mount for about 0.5 seconds when changing engine speed from idle to more than 1,000 rpm (with vehicle stopped).

OK or NG 

1. OK : INSPECTION END  .
2. NG : GO TO 4.