DTC Confirmation Procedure: Notes
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
With CONSULT-II
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT-II.
- Wait at least 10 seconds.
- Press "MAIN" switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press "RESUME/ACCEL" switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press "SET/COAST" switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press "CANCEL" switch for at least 10 seconds, then release it and wait at least 10 seconds.
- If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE " .