With GST
NOTE:
Be sure to read the explanation of "DRIVING PATTERN
"
before driving vehicle.
- Start engine.
- Drive vehicle according to "DRIVING PATTERN " .
- Stop vehicle.
- Select "MODE 1" with GST.
- If SRT of EVAP system is not set yet, go to the following step.
- If SRT of EVAP system is set, the result will be OK.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine.
It is not necessary to cool engine down before driving.
- Drive vehicle again according to the "DRIVING PATTERN " .
- Stop vehicle.
- Select "MODE 3" with GST.
- If P0442 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE " .
- If P0441 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE " for DTC P0441 .
- If P0441 and P0442 are not displayed on the screen, go to the following step.
- Select "MODE 1" with GST.
- If SRT of EVAP system is set, the result will be OK.
- If SRT of EVAP system is not set, go to step 6.