Testing Condition:

• Open engine hood before conducting following procedure. 
• If any of following condition is met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour. 

1. Fuel filler cap is removed. 
2. Refilled or drained the fuel. 
3. EVAP component parts is/are removed. 

• Before performing the following procedure, confirm that battery voltage is more than 11V at idle. 
  Fig 1: CONSULT II Display (3 Of 3)

  Courtesy of NISSAN MOTOR CO., U.S.A.

With CONSULT-II 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
2. Make sure the following conditions are met.

   FUEL LEVEL SE: 1.08 - 0.2V 

   COOLAN TEMP/S: 0 - 32°C (32 - 90°F) 

   FUEL T/TMP SE: 0 - 35°C (32 - 95°F) 

   INT A/TEMP SE: More than 0°C (32°F) 

   If NG, turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle) or refilling/draining fuel until the output voltage condition of the "FUEL LEVEL SE" meets within the range above and leave the vehicle for more than 1 hour. Then start from step 1).

3. Turn ignition switch OFF and wait at least 5 seconds.
4. Turn ignition switch ON.
5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.

   Follow the instruction displayed.

6. Make sure that "OK" is displayed.

   If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE  " .