Active Test: Notes
CAUTION:
- Do not perform active test while driving.
- Make sure to completely bleed air from the brake system.
- The ABS and brake (EBD) warning lamps turn on during the active test.
Operation Procedure
- Connect the CONSULT-II and CONSULT-II CONVERTER to the data link connector and start the engine.CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
- Touch "START (NISSAN BASED VHCL)" on the display screen.
- Touch "ABS".
If "ABS" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".
- Touch "ACTIVE TEST".
- The test item selection screen is displayed.
- Touch necessary test item.
- With the "MAIN ITEM" display shown in reverse, touch "START".
- The Active Test screen will be displayed, so conduct the following test.