LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Quest SL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System >> DTC P0500: VSS >> DTC Confirmation Procedure >> Testing Condition: >> With CONSULT-II
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With CONSULT-II

  1. Start engine (TCS switch or VDC switch OFF).
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to DIAGNOSTIC PROCEDURE  .

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    Fig 1: Testing Reference Chart
    G00775541Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: Displaying Data Monitor Screen
    G00775542Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .
scientia non olet · About LEMON Manuals