LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Quest SL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System >> DTC P1272, P1282: A/F Sensor 1 >> DTC Confirmation Procedure >> With CONSULT-II >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With CONSULT-II: Notes

  1. Start engine and warm it up to normal operating temperature.
  2. Select "A/F SEN1 (B1)" or "A/F SEN1 (B2)" in "DATA MONITOR" mode with CONSULT-II.
  3. 3. Check "A/F SEN1 (B1)" or "A/F SEN1 (B2)" indication.

    If the indication is constantly approx. 5V, go to DIAGNOSTIC PROCEDURE  .

    If the indication is not constantly approx. 5V, go to next step.

    4. Fig 1: Displaying Data Monitor Screen
    G00775731Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Turn ignition switch OFF, wait at least 10 seconds and then restart engine.
  5. Drive and accelerate vehicle to more than 40 km/h (25 MPH) within 20 seconds after restarting engine.
  6. Maintain the following conditions for about 20 consecutive seconds.
    Fig 2: Engine Speed Specification
    G00775732Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE:
    • Keep the accelerator pedal as steady as possible during the cruising.
    • If this procedure is not completed within 1 minute after restarting engine at step 4, return to step  4 .
  7. 7. If 1st trip DTC is displayed, go to DIAGNOSTIC PROCEDURE  .
scientia non olet · About LEMON Manuals