LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Quest SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Power Control System) >> Power Distribution System >> Ecu Diagnosis >> IPDM E/R (Intelligent Power Distribution Module Engine Room) >> Reference Value >> Values On The Diagnosis Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Values On The Diagnosis Tool

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
MONITOR ITEM CONDITION

Monitor Item Condition Value/Status
MOTOR FAN REQ Engine idle speed Changes depending on engine coolant temperature, air conditioner operation status, vehicle speed, etc. 1,2,3,4
AC COMP REQ Engine running A/C switch OFF Off
A/C switch ON (Compressor is operating) On
TAIL&CLR REQ Lighting switch OFF Off
Lighting switch 1ST, 2ND, HI or AUTO (Light is illuminated) On
HL LO REQ Lighting switch OFF Off
Lighting switch 2ND HI or AUTO (Light is illuminated) On
HL HI REQ Lighting switch OFF Off
Lighting switch HI On
FR FOG REQ Lighting switch 2ND or AUTO (Light is illuminated) Front fog lamp switch OFF Off
  • Front fog lamp switch ON
  • Daytime running light activated (Only for Canada models)
 On
FR WIP REQ Ignition switch ON Front wiper switch OFF STOP
Front wiper switch INT 1LOW
Front wiper switch LO Low
Front wiper switch HI Hi
WIP AUTO STOP Ignition switch ON Front wiper stop position STOP P
Any position other than front wiper stop position ACT P
WIP PROT Ignition switch ON Front wiper operates normally Off
Front wiper stops at fail-safe operation BLOCK
IGN RLY1 -REQ Ignition switch OFF or ACC Off
Ignition switch ON On
IGN RLY Ignition switch OFF or ACC Off
Ignition switch ON On
PUSH SW Release the push-button ignition switch Off
Press the push-button ignition switch On
INTER/NP SW Ignition switch ON CVT selector lever in any position other than P or N Off
Ignition switch ON CVT selector lever in P or N position On
ST RLY CONT Ignition switch ON Off
At engine cranking On
IHBT RLY -REQ Ignition switch ON Off
At engine cranking On
ST/INHI RLY Ignition switch ON Off
At engine cranking ST →INHI
The status of starter relay or starter control relay cannot be recognized by the battery voltage malfunction, etc. when the starter relay is ON and the starter control relay is OFF UNKWN
DETENT SW Ignition switch ON
  • Press the selector button with CVT selector lever in P position
  • CVT selector lever in any position other than P
 Off
Release the CVT selector button with CVT selector lever in P position On
S/L RLY -REQ None of the conditions below are present Off
  • Open the driver door after the ignition switch is turned OFF (for a few seconds)
  • Press the push-button ignition switch when the steering lock is activated
 On
S/L STATE Steering lock is activated LOCK
Steering lock is deactivated UNLK
[DTC B210A] is detected UNKWN
DTRL REQ
NOTE: This item is displayed, but cannot be monitored.
 Off
OIL P SW Ignition switch OFF, ACC or engine running Open
Ignition switch ON Close
THFT HRN REQ Not operated Off
  • Panic alarm is activated
  • Horn is activated with VEHICLE SECURITY (THEFT WARNING) SYSTEM
 On
HORN CHIRP Not operated Off
Door locking with Intelligent Key (horn chirp mode) On
CRNRNG LMP REQ
NOTE: This item is displayed, but cannot be monitored.
 Off
HOOD SW
NOTE: This item is displayed, but cannot be monitored.
 On
HL WASHER REQ
NOTE: This item is displayed, but cannot be monitored.
 On
scientia non olet · About LEMON Manuals