With Consult-II

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
Check the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 30°C (32 - 86°F)
Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.
Follow the instruction displayed.

Fig 1: DTC Confirmation Test (With Consult-II)
Courtesy of NISSAN MOTOR CO., U.S.A.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, GO TO "BASIC INSPECTION ".
Make sure that "OK" is displayed.
If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE ".
NOTE: Make sure that EVAP hoses are connected to the EVAP canister purge volume control solenoid valve properly.

Fig 2: Ensuring OK Is Displayed On Consult-II
Courtesy of NISSAN MOTOR CO., U.S.A.