Code Enable Criteria

WARNING: This page is about a different car, the 2002 Isuzu Rodeo Sport and 2002 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.

Following conditions must be met for DTC diagnostic test to run:

Engine is running.
Engine coolant temperature is 140°F (60°C) or more.
System voltage is between 10-16 volts.

When above conditions are met, one of the following test will run:

Decel Test

MAP signal is less than 35 kPa.
Throttle position is less than .8 percent.
Engine speed is between 1500-3500 RPM.

Decel test will fail if vehicle speed is less than 2 MPH. Decel test will pass if vehicle speed is 2 MPH or more.

Power Test

MAP signal is 70 kPa or more.
Throttle position is between 25-75 percent.
Engine speed is between 2200-4400 RPM.

Power test will fail if vehicle speed is less than 2 MPH. Power test will pass if vehicle speed is 2 MPH or more, without any VSS DTCs being set, or vehicle speed is 30 MPH or more and VSS DTCs are set.