LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 2043 (Body, Lock & Security System) >> Automatic Sliding Door System >> Sliding Door Open/Close Switch System Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sliding Door Open/Close Switch System Inspection

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. SLIDING DOOR OPEN/CLOSE SWITCH FUNCTION INSPECTION 

    Check sliding door open/close switch using switch operation.

    OK or NG 

    OK: Sliding door open/close switch is OK.

    NG: GO TO 2.

  2. SLIDING DOOR OPEN/CLOSE SWITCH SIGNAL INSPECTION 
    1. Turn ignition switch OFF.
    2. While operating the sliding door open/close switch, check voltage between sliding door control unit connector B60 (LH) or B143 (RH) terminal 2 and ground.
      TERMINALS VOLTAGE CHART

      Terminal Measuring condition Voltage (V) (Approx.)
      ( + ) ( - )
      2 Ground Sliding door open/close switch ON 0
      OFF 5

    OK or NG 

    OK: Sliding door open/close switch is OK.

    NG: GO TO 3.

    Fig 1: Checking Voltage Between Sliding Door Control Unit Connector B60 Or B143 Terminal 2 And Ground
    G04907168Courtesy of NISSAN MOTOR CO., U.S.A.
  3. SLIDING DOOR OPEN/CLOSE SWITCH CIRCUIT INSPECTION 
    1. Disconnect sliding door open/close switch and sliding door control unit.
    2. Check continuity between sliding door open/close switch connector B58 (LH) or B140 (RH) terminal 1 and sliding door control unit connector B60 (LH) or B143 (RH) terminal 2.

      1 - 2 : Continuity should exist. 

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace harness.

    Fig 2: Checking Continuity Between Sliding Door Open/Close Switch Connector Terminal 1 And Sliding Door Control Unit Connector Terminal 2
    G04907169Courtesy of NISSAN MOTOR CO., U.S.A.
  4. SLIDING DOOR OPEN/CLOSE SWITCH GROUND INSPECTION 

    Check continuity between sliding door open/close switch connector B58 (LH) or B140 (RH) terminal 2 and ground.

    2 - Ground : Continuity should exist. 

    OK or NG 

    OK: Replace the sliding door open/close switch.

    NG: Repair or replace harness.

    Fig 3: Checking Continuity Between Sliding Door Open/Close Switch Connector B58 Or B140 Terminal 2 And Ground
    G04907170Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals