Security Indicator Lamp Check

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

SECURITY INDICATOR LAMP ACTIVE TEST

With CONSULT-III

Check "THEFT IND" in "ACTIVE TEST" mode with CONSULT-III.

Without CONSULT-III

Disconnect BCM.

Check voltage between BCM harness connector M18 terminal 23 and ground.

BCM HARNESS CONNECTOR M18 TERMINAL 23 AND GROUND

Connector	Terminals		Voltage (V) (Approx.)
Connector	(+)	(-)	Voltage (V) (Approx.)
M18	23	Ground	Battery voltage

Fig 1: Checking Voltage Between BCM Harness Connector M18 Terminal 23 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Security indicator lamp is OK.

NG: GO TO 2.

SECURITY INDICATOR LAMP CHECK
Check indicator lamp condition.

OK or NG

OK: GO TO 3.

NG: Replace indicator lamp.
CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect BCM and security indicator lamp.
3. Check continuity between BCM connector (A) M18 terminal 23 and security indicator lamp harness connector (B) M37 terminal 2.
  
  Fig 2: Checking Harness Continuity
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  23 - 2: Continuity should exist.
4. Check continuity between BCM connector (A) M18 terminal 23 and ground.
  23 - Ground: Continuity should not exist.
OK or NG

OK: Check the following:
- 10A fuse [No. 19, located in fuse block (J/B)]
- Harness for open or short between security indicator lamp and fuse
NG: Repair or replace harness.