With Consult-II

WARNING: This page is about a different car, the 2002 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON and select DATA MONITOR mode for A/T with CONSULT-II.

Fig 1: Data Monitor Mode Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: DTC Confirmation Procedure With CONSULT -II (1 Of 4)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: DTC Confirmation Procedure With CONSULT -II (2 Of 4)
Courtesy of NISSAN MOTOR CO., U.S.A.

If the check result is NG, go to DIAGNOSTIC PROCEDURE .

If the check result is OK, go to following step.
Turn ignition switch ON and select DATA MONITOR mode for ENGINE with CONSULT-II.

Fig 4: DTC Confirmation Procedure With CONSULT -II (3 Of 4)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 5: DTC Confirmation Procedure With CONSULT -II (4 Of 4)
Courtesy of NISSAN MOTOR CO., U.S.A.
Start engine and maintain the following conditions for at least 3 consecutive seconds. Then release accelerator pedal completely.
VHCL SPEED SE: 10 km/h (6 MPH) or more

THRTL POS SEN: Approximately 3V or less

Selector lever: D position (O/D ON)

If the check result is NG, go to DIAGNOSTIC PROCEDURE .

If the check result is OK, go to following step.
Maintain the following conditions for at least 3 consecutive seconds. Then release accelerator pedal completely.
VHCL SPEED SE: 10 km/h (6 MPH) or more

Accelerator pedal: Wide open throttle

Selector lever: D position (O/D ON)