Setting Change Function
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
The settings of the automatic driving position system can be changed, using CONSULT-II and the display in the center of the instrument panel.
X: Applicable
-: Not Applicable
SETTING CHANGE FUNCTION CHART
| Setting item | Content | CONSULT-II (WORK SUPPORT) | Display unit | Default setting | Factory setting |
|---|---|---|---|---|---|
| SEAT SLIDE VOLUME SET | The distance at exiting operation can be selected from the following 3 modes. | 40mm | - | X | X |
| 80mm | - | - | |||
| 150mm | - | - | |||
| Sliding Driver Seat When Entry/Exiting Vehicle | The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated) | ON | ON: Indicator lamp ON | - | X |
| OFF | OFF: Indicator lamp OFF | X | - | ||
| Reset custom settings* | All settings to default. | - | Default: Setting button ON | - | - |
*: Setting of sliding driver seat for entry/exit of vehicle is ON at factory-shipment. But if custom settings are reset, setting turns OFF.
It is possible to set sliding driver seat for entry/exit of vehicle by pressing set switch.
SETTING CHANGE OPERATION CHART
| Content | Setting change operation | Indicator LEDs |
|---|---|---|
| The seat sliding turnout and return at entry/exit can be operated. | Press the set switch for than 10 seconds | Blinking twice |
| The seat sliding turnout and return at entry/exit can be not operated. | Blinking once |
NOTE:
After the setting is registered, the new setting is effective, even if the battery is disconnected.