LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1107 (General Information) >> Consult-II Checking System >> Function and System Application
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Function and System Application

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
FUNCTION AND SYSTEM APPLICATION CHART

Diagnostic test mode Function ENGINE TRANSMISSION ALL MODE AWD/4WD AIR BAG METER A/C AMP BCM IPDM E/R AUTO DRIVE POS. ABS ABS (Including VDC) AIR PRESSURE MONITOR NVIS (NATS)
Work support This mode enables a technician to adjust some devices faster and more accurately by following the indications on CONSULT-II. (1) (1) - - - (1) - (1) - (1) (1) -
Self-diagnostic results Self-diagnostic results can be read and erased quickly. (1) (1) (1) (1) (1) (1) (1) (1) (1) (1) (1) (1)
Trouble diagnostic record Current self-diagnostic results and all trouble diagnostic records previously stored can be read. - - - (1) - - - - - - - -
Data monitor Input/Output data in the ECM can be read. (1) (1) (1) - (1) (1) (1) (1) (1) (1) (1) -
Active test Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECMs and also shifts some parameters in a specified range. (1) - (1) - - (1) (1) (1) (1) (1) - -
DTC confirmation The results of SRT (System Readiness Test) and the self-diagnosis status/result can be confirmed. (1) - - - - - - - - - - -
DTC work support Select the operating condition to confirm Diagnosis Trouble Codes. (1) - - - - - - - - - - -
ECM (ECU) part number ECM (ECU) part number can be read. (1) (1) (1) - - (1) - (1) (1) (1) (1) -
ECU discriminated No. Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed. - - - (1) - - - - - - - -
Function test Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". (1) (1) - (1) - - - - (1) (1) - -
Control unit initialization All registered ignition key IDs in NATS components can be initialized and new IDs can be registered. - - - - - - - - - - - (1)
CALIB data Characteristic information for TCM and CVT assembly can be read. Do not use, but displayed. - (1) - - - - - - - - - -
Configuration (2) - - - - - - (1) - - - - - -
(1) Applicable
(2) This item is indicated, but it is what it does not use.
scientia non olet · About LEMON Manuals