Rear Combination Light Assembly: Installation

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
1. Install the pin, and then install the rear combination light assembly LH.
2. Install the 3 nuts.
3. Connect the connector.
INSTALL REAR FLOOR SERVICE HOLE COVER
1. Install the rear floor service hole cover.
INSTALL REAR BUMPER COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.

INSTALL LICENSE PLATE LIGHT ASSEMBLY
1. Attach the 2 claws and install the license plate light assembly.
2. Connect the connector.
INSTALL BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
INSTALL BACK DOOR SIDE GARNISH RH (See REASSEMBLY )
INSTALL BACK DOOR SIDE GARNISH LH (See REASSEMBLY )
INSTALL BACK DOOR GARNISH CENTER (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.