BOSE System

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Owner's Manual for audio system operating instructions. Power is supplied at all times

Through 15A fuse [No. 37, located in the fuse and fusible link box]
To audio unit terminal 6,
To BOSE speaker amp. terminal 1.

With the ignition switch in the ACC or ON position, power is supplied

Through 10A fuse [No. 6, located in the fuse block (J/B)]
To audio unit terminal 10.

Ground is supplied through the case of the audio unit.

Ground is also supplied

To BOSE speaker amp. terminal 17
Through body ground B5 and B29

Audio unit and A/C and audio controller are connected by FPC (Flexible Print Circuit). A/C and audio controller integrates A/C switches and audio switches.

When A/C and audio controller is pushed to audio switch, it send audio signal to audio unit. Then audio signals are supplied

Through audio unit terminals 1, 2, 3, 4, 13, 14, 15, and 16
To BOSE speaker amp. terminals 23, 24, 25, 26, 27, 28, 29, and 30.

Audio signals are amplified by the BOSE speaker amp.

The amplified audio signals are supplied

Through BOSE speaker amp. terminals 13, 14, 15, and 16
To terminals 1 and 2 of front door speaker LH and RH
To terminals 1 and 2 of tweeter LH and RH,
Through BOSE speaker amp. terminals 9, 10, 11, and 12
To terminals 1 and 2 of rear door speaker LH and RH,
Through BOSE speaker amp. terminals 2, and 18
To terminals 1 and 2 of woofer.

When one of steering wheel audio control switches is pushed to volume up, seek up, or mode ON, resistance in steering wheel audio control switch circuit changes depending on which button is pushed. This will change voltage. Power is supplied

From audio unit terminal 22
Through combination switch (spiral cable) terminals 24 and 20
To steering wheel audio control switch.

Ground is supplied

From steering wheel audio control switch
Through combination switch (spiral cable) terminals 17 and 31
To audio unit terminal 25.

When one of steering wheel audio control switches is pushed to volume down, seek down, or power ON, resistance in steering wheel audio control switch circuit changes depending on which button is pushed. This will change voltage. Power is supplied

From audio unit terminal 23
Through combination switch (spiral cable) terminals 32 and 16
To steering wheel audio control switch.

Ground is supplied

From steering wheel audio control switch
Through combination switch (spiral cable) terminals 17 and 31
To audio unit terminal 25.