DTC Confirmation Procedure
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-III
- Turn ignition switch ON. (Do not start engine.)
- Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
- Wait for at least 2 consecutive seconds.
- If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".