Inspection Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the display control unit for damage, bend and loose connection (unit side and connector side).
OK or NG

OK: GO TO 2.

NG: Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of display control unit.

Check the resistance between the display control unit harness connector terminals.

HARNESS FOR OPEN CIRCUIT

Display control unit harness connector			Resistance (Ω)
Connector No.	Terminal No.		Resistance (Ω)
M95	25	26	Approx. 54 - 66

OK or NG

OK: GO TO 3.

NG: Repair the display control unit branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the display control unit. Refer to SCHEMATIC

OK or NG

OK:
- Present error: Replace the display control unit. Refer to REMOVAL AND INSTALLATION
- Past error: Error was detected in the display control unit branch line.
NG: Repair the power supply and the ground circuit.