LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2121 (Body, Lock & Security System) >> Automatic Sliding Door System >> Self-Diagnosis Procedures >> Operating Check Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operating Check Mode

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Operating check mode allows self-diagnosis of the automatic sliding door system.

To activate operating check mode on the automatic sliding door, perform the following steps:

  1. Turn ignition switch OFF.
  2. Turn automatic door main switch OFF (system cancelled).
  3. Place A/T selector lever in P position.
  4. Open sliding door RH or LH manually.
  5. Have an assistant press and hold the sliding door open/close switch RH or LH.
  6. While the assistant continues to hold the sliding door open/close switch RH or LH, turn ignition switch ON (DO NOT start engine).
  7. After approximately 5 seconds, the back door warning chime will sound for 0.5 seconds.
  8. Release the sliding door open/close switch RH or LH.
  9. Within 8 seconds of the back door warning chime sounding, press the automatic door main sliding door open/close switch RH or LH 5 times in rapid succession.
  10. After approximately 5 seconds, the back door warning chime will sound for 1 second.
  11. Release the automatic door main sliding door open/close switch RH or LH.
  12. Immediately close the sliding door RH or LH manually.
  13. Turn automatic door main switch ON.
  14. Open and close the back door with the automatic door main sliding door open/close switch RH or LH to activate operating check mode.

Self-diagnosis results are indicated by the back door warning chime.

SELF-DIAGNOSIS RESULTS CHART

Back door warning chime order Back door warning chime length
Start self-diagnosis 1.5 seconds
- OK NG
1. Operating conditions diagnosis 0.5 seconds 0.2 seconds
2. Sliding door encoder Diagnosis 0.5 Seconds 0.2 seconds
3. Sliding door clutch Diagnosis 0.5 Seconds 0.2 seconds
4. Sliding door motor Diagnosis 0.5 Seconds 0.2 seconds
5. Cinch latch motor Diagnosis 0.5 Seconds 0.2 seconds
Restart self-diagnosis 1.5 seconds
SELF-DIAGNOSIS RESULTS CHART

Item/Refer to NG Result
1. Operating conditions diagnosis result One of the following operating conditions no longer met: ignition switch ON, automatic door main switch ON, A/T selector lever in P position
2. SLIDING DOOR ENCODER DIAGNOSIS RESULT  Sensor diagnosis/short, pulse signal, pulse signal direction
3. SLIDING DOOR CLUTCH DIAGNOSIS RESULT  Sliding door clutch does not operate
4. SLIDING DOOR MOTOR DIAGNOSIS RESULT  Sliding door motor does not operate (no operating current)
5. CINCH LATCH MOTOR DIAGNOSIS RESULT  Cinch latch motor does not operate (no operating current)

Turn ignition switch OFF to end input signal check mode.

scientia non olet · About LEMON Manuals