LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2286 (Engine Control System - DTCS P0444 Through P1168) >> DTC P0453 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With GST
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With GST

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON.
  5. Turn ignition switch OFF and wait at least 10 seconds.
  6. Start engine wait at least 10 seconds.
  7. Select Service $07 with GST.
  8. Check 1st trip DTC.
  9. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
Fig 1: Checking Voltage Between ECM Terminal 107 And Ground
G04900511Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals