With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: Identifying CONSULT-II - DATA MONITOR
Courtesy of NISSAN NORTH AMERICA, INC.
Make sure that the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 30°C (32 - 86°F)
Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.
Follow the instruction displayed.

Fig 2: Identifying CONSULT-II - EVAP SML LEAK P0442/P1442
Courtesy of NISSAN NORTH AMERICA, INC.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, go to "BASIC INSPECTION ".
Make sure that "OK" is displayed.
If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE ".

NOTE: Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

Fig 3: Identifying CONSULT-II - EVAP SML LEAK P0442/P1442
Courtesy of NISSAN NORTH AMERICA, INC.