Diagnostic Procedure

1. Turn ignition switch ON.
2. Connect CONSULT-II and select "DATA MONITOR" mode.
3. Select "LOAD SIGNAL" and check indication under the following conditions.
   ELECTRICAL LOAD SIGNAL DIAGNOSIS CONDITION
   
   

   Condition	Indication
   Lighting switch: ON at 2nd position	ON
   Lighting switch: OFF	OFF

OK or NG 

1. OK : INSPECTION END 
2. NG : GO TO 2.
   Fig 1: DATA MONITOR - CONSULT-II Display

   Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to "HEADLAMP (FOR USA) " or "HEADLAMP (FOR CANADA) - DAYTIME LIGHT SYSTEM ".

1. : INSPECTION END