October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
With GST
- Lift up drive wheels.
- Start engine (TCS switch or VDC switch OFF) and warm it up to normal operating temperature.
- Turn ignition switch OFF, wait at least 10 seconds.
- Start engine and wait at least 70 seconds.
- Set voltmeter probes to ECM terminals 32 (EVAP control system pressure sensor signal) and ground.
- Check EVAP control system pressure sensor value at idle speed and note it.
- Establish and maintain the following conditions for at least 1 minute.
Courtesy of NISSAN MOTOR CO., U.S.A. SWITCH POSITION REFERENCE TABLE
| Item |
Condition |
| Air conditioner switch |
ON |
| Headlamp switch |
ON |
| Rear window defogger switch |
ON |
| Engine speed |
Approx. 3, 000 RPM |
| Gear position |
Any position other than P, N or R |
- Verify that EVAP control system pressure sensor value stays 0.1V less than the value at idle speed (measured at step 6) for at least 1 second.
- If NG, go to
"DIAGNOSTIC PROCEDURE ".