Security Indicator Lamp Check

WARNING: This page is about a different car, the 2007 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

SECURITY INDICATOR LAMP ACTIVE TEST

With CONSULT-III

Check "THEFT IND" in "ACTIVE TEST" mode with CONSULT-III.

Without CONSULT-III

Disconnect BCM.

Check voltage between BCM harness connector M18 terminal 23 and ground.

CONNECTOR TERMINAL VOLTAGE SPECIFICATION

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
M18	23	Ground	ON	0
M18	23	Ground	OFF	Battery voltage

OK or NG

OK: Security indicator lamp is OK.

NG: GO TO 2.

Fig 1: Checking Voltage Between BCM Harness Connector M18 Terminal 23 And Ground

SECURITY INDICATOR LAMP CHECK
Check security indicator lamp condition.

OK or NG

OK: GO TO 3.

NG: Replace security indicator lamp.
CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect BCM and combination meter.
3. Check continuity between BCM connector M18 (A) terminal 23 and combination meter connector M24 (B) terminal 16.
  23 - 16 : Continuity should exist.
4. Check continuity between BCM connector M18 (A) terminal 23 and ground.
  23 - Ground : Continuity should not exist.
OK or NG

OK: Check the following:
- 10A fuse [No. 19, located in fuse block (J/B)]
- Harness for open or short between combination meter and fuse
NG: Repair or replace harness.

Fig 2: Checking Continuity Between BCM Connector M18 Terminal 23 And Ground