LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2005 >> Sentra SE-R Spec V >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Audio Visual, Navigation & Telephone System) >> Service Information >> Audio >> Steering Switch Check (Without Bluetooth)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Switch Check (Without Bluetooth)

WARNING: This page is about a different car, the 2009 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. AUDIO UNIT SELF-DIAGNOSIS MODE CHECK
    1. Start audio unit self-diagnosis mode. Refer to "SELF-DIAGNOSIS MODE ".
    2. Operate steering switch.

    Does steering switch operate normally? 

    YES: Inspection End.

    NO: GO TO 2.

  2. CHECK HARNESS
    1. Turn ignition switch OFF.
    2. Disconnect audio unit connector M43 and spiral cable connector M30.
    3. Check continuity between audio unit connector terminal and spiral cable connector terminal.
      TERMINALS CONTINUITY REFERENCE

      Terminals Continuity
      A B
      Connector Terminal Connector Terminal
      M43 6 M30 33 Yes
      15 25
      16 31
    4. Check continuity between audio unit and ground.
    TERMINALS CONTINUITY REFERENCE

    Terminals Continuity
    A (-)
    Connector Terminal
    M43 6 Ground No
    15
    16
    Fig 1: Checking Continuity Between Audio Unit And Ground
    G04928637Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 3.

    NG: Repair harness.

  3. SPIRAL CABLE CHECK
    1. Disconnect spiral cable connector M78.
    2. Check continuity between spiral cable terminals.

      15 - 33 : Continuity should exist. 

      17 - 31 : Continuity should exist. 

      19 - 25 : Continuity should exist. 

      Fig 2: Checking Continuity Between Spiral Cable Terminals
      G04928635Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 4.

    NG: Replace spiral cable. Refer to "REMOVAL AND INSTALLATION ".

  4. CHECK STEERING SWITCH RESISTANCE

    Check resistance between spiral cable connector M102 terminals.

    TERMINALS RESISTANCE REFERENCE

    Terminal Signal name Condition Resistance (Ω) (Approx.)
    17 19 Seek (down) Depress (station) down switch. 165
    Power Depress power switch. 0
    Volume (down) Depress volume down switch. 487
    15 19 Seek (up) Depress (station) up switch. 165
    Mode Depress mode switch. 0
    Volume (up) Depress volume up switch. 487
    Fig 3: Checking Resistance Between Spiral Cable Connector M102 Terminals
    G04928636Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Inspection End.

    NG: Replace steering switch. Refer to "REMOVAL AND INSTALLATION ".