Stop Lamp Switch

WARNING: This page is about a different variant/trim than selected.

Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.

Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.

STOP LAMP SWITCH TERMINALS 1 AND 2 TERMINAL CONTINUITY CONDITIONS

Condition	Continuity
When brake pedal is fully released.	Should not exist.
When brake pedal is depressed.	Should exist.

If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL AND BRACKET ", and perform step 3 again.