6. Check Throttle Control Motor Relay Input Signal Circuit-II
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Disconnect IPDM E/R harness connector E124.
- Check continuity between ECM terminal 3 and IPDM E/R terminal 42.
Refer to WIRING DIAGRAM.
- Continuity should exist.
- Also check harness for short to ground and short to power.
OK or NG
- OK: GO TO 8.
- NG: GO TO 7.