ASCD Clutch Switch (M/T Models)

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF.
Disconnect ASCD clutch switch harness connector.
Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.

Fig 1: Checking Continuity Between Harness Connector terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.

TERMINALS CONTINUITY REFERENCE

Condition	Continuity
Clutch pedal: Fully released.	Should exist.
Clutch pedal: Slightly depressed.	Should not exist.

If NG, adjust ASCD clutch switch installation, refer to "CLUTCH SYSTEM ", and perform step 3 again.