LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2007 >> 350Z 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - Component Testing >> ASCD Brake Switch >> Diagnostic Procedure >> A/T Models
April 5, 2026: LEMON Manuals is launched! Read the announcement.

A/T Models

  1. CHECK OVERALL FUNCTION-I 

    With CONSULT-III 

    1. Turn ignition switch ON.
    2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT-III.
    3. Check "BRAKE SW1" indication under the following conditions.
      BRAKE PEDAL CONDITION AND INDICATION REFERENCE

      CONDITION INDICATION
      Brake pedal: Slightly depressed OFF
      Brake pedal: Fully released ON

    Without CONSULT-III 

    1. Turn ignition switch ON.
    2. Check voltage between ECM terminal 126 and ground under the following conditions.
      VOLTAGE SPECIFICATION

      CONDITION VOLTAGE
      Brake pedal: Slightly depressed Approximately 0V
      Brake pedal: Fully released Battery voltage

    OK or NG 

    OK: INSPECTION END 

    NG: GO TO 2.

    Fig 1: Checking Voltage Between ECM Terminal 126 And Ground
    G04875400Courtesy of NISSAN NORTH AMERICA, INC.
  2. CHECK ASCD BRAKE SWITCH POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ASCD brake switch harness connector.
    3. Turn ignition switch ON.
      Fig 2: Identifying ASCD Brake Switch And Stop Lamp Switch
      G04875402Courtesy of NISSAN NORTH AMERICA, INC.
    4. Check voltage between ASCD brake switch terminal 1 and ground with CONSULT-III or tester.

      Voltage: Battery voltage 

    OK or NG 

    OK: GO TO  4.

    NG: GO TO 3.

    Fig 3: Checking Voltage Between ASCD Brake Switch Terminal 1 And Ground
    G04875403Courtesy of NISSAN NORTH AMERICA, INC.
  3. DETECT MALFUNCTIONING PART 

    Check the following.

    • Fuse block (J/B) connector E101
    • 10A fuse
    • Harness for open or short between ASCD brake switch and fuse

      : Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK ASCD BRAKE SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between ECM terminal 126 and ASCD brake switch terminal 2. Refer to WIRING DIAGRAM .

      Continuity should exist  .

    4. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  6.

    NG: GO TO 5.

  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors E108, M15
    • Harness for open or short between ECM and ASCD brake switch

      : Repair open circuit or short to ground or short to power in harness or connectors.

  6. CHECK ASCD BRAKE SWITCH 

    Refer to "COMPONENT INSPECTION "

    OK or NG 

    OK: GO TO 7.

    NG: Replace ASCD brake switch.

  7. CHECK INTERMITTENT INCIDENT 

    Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    : INSPECTION END 

scientia non olet · About LEMON Manuals