Component Inspection (ASCD Brake Switch)

1. Turn ignition switch OFF.
2. Disconnect ASCD brake switch harness connector.
3. Check the continuity between ASCD brake switch terminals under the following conditions.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Existed
   		Slightly depressed	Not existed

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Adjust ASCD brake switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
2. Check the continuity between ASCD brake switch terminals under the following conditions.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Existed
   		Slightly depressed	Not existed

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace ASCD brake switch.