Component Function Check

Without CONSULT-III 

1. Lift up the vehicle.
2. Activate "INSPECTION MODE 1" ( MODE 1 ) to start engine, and warm up engine to normal operating temperature.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Turn ignition switch ON.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Activate "INSPECTION MODE 1" ( MODE 1 ) to start engine, and wait at least 150 seconds.
7. Set voltmeter probes to ECM harness connector and ground.
   ECM HARNESS CONNECTOR AND GROUND
   
   

   ECM		Ground
   Connector	Terminal
   E10	86 (EVAP control system pressure sensor signal)	Ground

8. Check EVAP control system pressure sensor value when vehicle is stopped and note it.
9. Establish and maintain the following conditions for at least 1 minute.
   VEHICLE SPEED REFERENCE
   
   

   Vehicle speed	70 km/h (43 MPH) or more
   Shift lever	D position

10. Verify that EVAP control system pressure sensor value stays 0.1V less than the value when vehicle is stopped (measured at step  8) for at least 1 second.

Is the inspection result normal? 

YES: INSPECTION END

NO: Go to "DIAGNOSIS PROCEDURE ".