Remote Keyless Entry Switch Operation (Fully Closed → Fully Open Operation)

When the keyfob button is pressed for at least 0.5 seconds, sliding door control unit terminal 7 receives the signal.
The sliding door control unit checks the automatic transaxle selector lever (A/T device) position through terminal 18, vehicle speed through terminal 7 and battery voltage.
For automatic sliding door LH, fuel lid door status is checked through sliding door control unit terminal 13.
Door lock status is checked through terminal 3, if the door is locked, the sliding door control unit will unlock the door through terminal 30.
When the sliding door control unit receives the signal, if the auto sliding door operating enable conditions are met, it sends the unlock signal to the sliding door latch control unit.
When the sliding door latch control unit receives the signal, it supplies voltage from terminal 10 to operate the release actuator and unlatches the door lock.
The sliding door control unit supplies power from terminal 33 and supplies power from terminal 34 to the magnetic clutch to operate the sliding door motor and slide the sliding door in the open direction. (At this time, it also executes speed control, input reverse, and overload reverse control.)
When the sliding door is opened to the full-open position, the full-open position is detected by the encoder (built into the sliding door motor assembly), and the sliding door control unit switches the sliding door motor OFF and controls the magnetic clutch ON → half clutch → OFF.
The sliding door is mechanically held in the fully open position by the checker.