Steering Column: Inspection
- When the steering wheel does not turn smoothly, check the steering column as follows:
- Check the column bearings for damage or unevenness. Lubricate with recommended multipurpose grease. Replace the steering column as an assembly, if necessary.
- Check the column tube for deformation or breakage. Replace the steering column as an assembly, if necessary.
- If the vehicle has been involved in a collision, or if noise and rattles are heard during a turn, check the length "L" of the column. If out of specification, replace the steering column as an assembly.
Steering column length "L" : 428 mm (16.85 in)
- Check for proper lubrication, apply grease as necessary.
- Check for wear around the seal edges, replace as necessary.
- Check for corrosion or pitting around the seal sliding area.
- Replace the seal and shaft in case of seal edge wear or damage.
- After installing the steering column, check the tilt mechanism for proper operation.
Tilt mechanism range (manual tilt) : 3° per notch at 6 steps
CAUTION:
- Do not exert any load or impact in the axial direction immediately before or after column removal.
- After installation, check for smooth steering wheel rotation, without any catches or noise.
- Replace the column if it is depleted of grease, worn, damaged, or if any scratches or coating separation is present on the shaft seal area.
- The nut on the upper joint may not be reused.
- During lower joint detachment, insert a tool into the yoke groove to prevent gouging damage.