LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2007 >> X-Trail LE >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> Abs >> Trouble Diagnosis >> Control Unit Input/Output Signal Standard >> Reference Value From Consult-II
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reference Value From Consult-II

CAUTION: The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short - circulated.
DATA MONITOR ITEM CHART

Data monitor item Display item Data monitor Reference: Inspection item
Condition Reference values in normal operation
FR LH SENSOR
FR RH SENSOR
RR LH SENSOR
RR RH SENSOR		 Wheel speed calculated using signals from all four wheel sensors Vehicle stopped 0 [km/h] "INSPECTION 1: WHEEL SENSOR CIRCUIT "
Vehicle running ((1)) Nearly matches the speedometer display (± 10 % or less)
DECEL G-SEN 1
DECEL G-SEN 2		 Fore-and-aft gravity detected by G sensor When vehicle is stopped on level ground OFF "INSPECTION 5: G SENSOR CIRCUIT (ONLY AWD MODELS) "
When G sensor is tilted toward the front with G sensor mounting nuts removed ON
ABS IN SOL
ABS OUT SOL		 Operation status of all solenoid valve When the actuator solenoid operates or during a fail-safe ON "INSPECTION 4: ABS ACTUATOR RELAY OR ABS MOTOR RELAY POWER CIRCUIT "
When the actuator relay operates and the actuator solenoid does not operate OFF
STOP LAMP SW Brake pedal operation status Brake pedal depressed ON Stop lamp switch circuit
Brake pedal not depressed OFF
MOTOR RELAY Motor and motor relay operation status When the motor relay and motor are operating ON "INSPECTION 4: ABS ACTUATOR RELAY OR ABS MOTOR RELAY POWER CIRCUIT "
When the motor relay and motor are not operating OFF
ACTUATOR RELAY Actuator relay operation status When the actuator relay is operating OFF
When the actuator relay is not operating ON
ABS WARN LAMP ABS warning lamp on condition ((2)) When ABS warning lamp is ON ON "BASIC INSPECTION 3: INSPECTION OF ABS WARNING LAMP "
When ABS warning lamp is OFF OFF
BATTERY VOLT Battery voltage supplied to ABS actuator and electric unit (control unit) Ignition switch ON 10 - 16 V "INSPECTION 3:ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT "
EBD SIGNAL
ABS SIGNAL		 EBD operation
ABS operation		 EBD active
ABS active		 ON EBD system
ABS system
EBD not active
ABS not active		 OFF
EBD FAIL SIG
ABS FAIL SIG		 System fail signal status EBD Fail
ABS Fail		 ON
EBD normal
ABS normal		 OFF
(1) Confirm tire pressure is the standard value.
(2) ABS warning lamp ON/OFF timing.

ON: When the ignition switch is turned ON or when an error is detected.
OFF: After the ignition switch is turned ON (when system is normal).
scientia non olet · About LEMON Manuals