DTC Confirmation Procedure

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5V at idle. 

WITH CONSULT-II 

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for at least 60 seconds.
4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Screen Display - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

Follow the procedure "WITH CONSULT-II" above.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5V at idle. 

WITH CONSULT-II 

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for at least 10 seconds.
4. If a 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

Fig 1: Screen Display - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

Follow the procedure "WITH CONSULT-II" above.