LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (Hybrid)) >> Component Diagnosis >> P0451 EVAP Control System Pressure Sensor >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Activate "INSPECTION MODE 1 " to start engine, and wait at least 40 seconds.
      NOTE: Do not depress accelerator pedal even slightly.
    3. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES : Go to "DIAGNOSIS PROCEDURE ".

    NO : INSPECTION END

scientia non olet · About LEMON Manuals