April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Function Check

WARNING: This page is about a different variant/trim than selected.

START
Make sure that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5,000 km (3,107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30°C (68 - 86°F)
- Engine coolant temperature: 75 - 95°C (167 - 203°F)
- Transmission: Warmed-up (After the engine is warmed up to normal operating temperature, drive vehicle for 5 minutes.)
- Engine speed: Idle
GO TO 2.
PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Lift up the vehicle.
2. Perform "BASIC INSPECTION : Special Repair Requirement ".
3. Turn ignition switch ON (READY).
4. Depressed the accelerator pedal and keep it.
5. Shift the selector lever to N position with engine running.
  CAUTION: Never leave the selector lever in the N position for a long period of time. In the N position, the engine operates but electricity cannot be generated.
6. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
7. Make sure that monitor items are within the SP value.
8. Shift the selector lever to P position.
Is the inspection result normal?

YES : END

NO : Go to "DIAGNOSIS PROCEDURE ".