LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Altima Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Hybrid) >> Component Diagnosis >> P0130 A/F Sensor 1 >> Component Function Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Function Check

  1. PERFORM COMPONENT FUNCTION CHECK

    With GST 

    CAUTION: Always drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
    1. Activate "INSPECTION MODE 1 " to start engine, and warm up engine to normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON (READY).
    4. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes.
    5. Set D position, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).
      NOTE: Never apply brake during releasing the accelerator pedal.
    6. Repeat steps  4 to  5 for five times.
    7. Stop the vehicle and turn ignition switch OFF.
    8. Turn ignition switch ON.
    9. Turn ignition switch OFF and wait at least 10 seconds.
    10. Turn ignition switch ON (READY).
    11. Repeat steps  4 to  5 for five times.
    12. Stop the vehicle and connect GST to the vehicle.
    13. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES : Go to "DIAGNOSIS PROCEDURE ".

    NO : INSPECTION END

scientia non olet · About LEMON Manuals