Diagnostic Procedure: Notes

Do you have CONSULT-III?

Yes or No 

YES: GO TO  2.

NO: GO TO  3.

With CONSULT-III 

1. Start engine and let it idle.
2. Select "COOLING FAN" in "ACTIVE TEST" mode with CONSULT-III.
3. Make sure that cooling fans-1 and -2 operate at each speed (LOW/MID/HI).

OK or NG 

OK: GO TO  4.

NG: Check cooling fan control circuit. (Go to "PROCEDURE A .")

Without CONSULT-III 

1. Perform IPDM E/R auto active test and check cooling fan motors operation, refer to "AUTO ACTIVE TEST ."
2. Make sure that cooling fans-1 and -2 operate at each speed (Low/Middle/High).

OK or NG 

OK: GO TO  4.

NG: Check cooling fan control circuit. (Go to "PROCEDURE A .")

Refer to "CHECKING COOLING SYSTEM FOR LEAKS ."

OK or NG 

OK: GO TO  5.

NG: Check the following for leak. Refer to "CHECKING COOLING SYSTEM FOR LEAKS ."

• Hose
• Radiator
• Water pump

Refer to "RADIATOR ."

OK or NG 

OK: GO TO  6.

NG: Replace radiator cap.

Refer to "THERMOSTAT AND THERMOSTAT HOUSING ."

OK or NG 

OK: GO TO  7.

NG: Replace thermostat

Refer to "COMPONENT INSPECTION ."

OK or NG 

OK: GO TO  8.

NG: Replace engine coolant temperature sensor.

If the cause cannot be isolated, go to "MAIN 12 CAUSES OF OVERHEATING ."

>> INSPECTION END