DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10V at idle.

Start engine and warm it up to normal operating temperature.
Rev engine from idle to 2, 000 rpm for 10 times.
Check DTC.
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".