Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : Special Repair Requirement ".
4. Turn ignition switch ON.
5. Set shift lever to D position.
6. Check the voltage between ECM harness connector terminals.
   TERMINALS VOLTAGE REFERENCE
   
   

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   F8	37 (TP sensor 1 signal)	F8	36 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36V
   					Fully depressed	Less than 4.75V
   	38 (TP sensor 2 signal)				Fully released	Less than 4.75V
   					Fully depressed	More than 0.36V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

1. Replace electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

   INSPECTION END