Component Inspection

1. Reconnect all harness connectors disconnected.
2. Turn ignition switch ON.
3. Check the voltage between ECM harness connector terminals.
   TERMINALS VOLTAGE REFERENCE
   
   

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   E16	81 (APP sensor 1 signal)	E16	84 (Sensor ground)	Accelerator pedal	Fully released	0.5 - 1.0V
   					Fully depressed	4.2 - 4.8V
   	82 (APP sensor 2 signal)		100 (Sensor ground)		Fully released	0.25 - 0.5V
   					Fully depressed	2.0 - 2.5V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

1. Replace accelerator pedal assembly.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

   INSPECTION END