LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Rogue S, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Component Testing (CALIFORNIA) >> Fuel Pump >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK FUEL PUMP POWER SUPPLY CIRCUIT-I
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Turn ignition switch ON.
    4. Check the voltage between ECM harness connector and ground.
      TERMINALS VOLTAGE REFERENCE

      ECM Ground Voltage
      Connector Terminal
      F7 14 Ground Battery voltage

    Is the inspection result normal?

    YES: GO TO  4.

    NO: GO TO 2.

  2. CHECK FUEL PUMP POWER SUPPLY CIRCUIT-II
    1. Turn ignition switch OFF.
    2. Disconnect IDPDM E/R harness connector E13.
    3. Check the continuity between IPDM E/R harness connector and ECM harness connector.
      TERMINALS CONTINUITY REFERENCE

      ECM IPDM E/R Continuity
      Connector Terminal Connector Terminal
      F7 14 E13 33 Existed

    Is the inspection result normal?

    YES: GO TO  4.

    NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E6, F123
    • IPDM E/R connector E13
    • Harness for open or short between ECM and IPDM E/R

    Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK 15A FUSE
    1. Disconnect 15A fuse (No. 57) from IPDM E/R.
    2. Check 15A fuse.

    Is the inspection result normal?

    YES: GO TO 5.

    NO: Replace fuse.

  5. CHECK FUEL PUMP POWER SUPPLY CIRCUIT-III
    1. Disconnect "fuel level sensor unit and fuel pump" harness connector.
    2. Check the continuity between IPDM E/R harness connector and "fuel level sensor unit and fuel pump" and ground.
      TERMINALS CONTINUITY REFERENCE

      IPDM E/R Fuel level sensor unit and fuel pump Continuity
      Connector Terminal Connector Terminal
      E14 46 B40 5 Existed

    Is the inspection result normal?

    YES: GO TO  7.

    NO: GO TO 6.

  6. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E105, M77
    • Harness connectors M11, B1
    • Harness for open or short between "fuel level sensor unit and fuel pump" and IPDM E/R

    Repair open circuit or short to ground or short to power in harness or connectors.

  7. CHECK FUEL PUMP GROUND CIRCUIT
    1. Check the continuity between "fuel level sensor unit and fuel pump" and ground.
      TERMINALS CONTINUITY REFERENCE

      Fuel level sensor unit and fuel pump Ground Continuity
      Connector Terminal
      B40 3 Ground Existed
    2. Also heck harness for short to power.

    Is the inspection result normal?

    YES: GO TO 8.

    NO: Repair open circuit or short to power in harness or connectors.

  8. CHECK FUEL PUMP

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal?

    YES: GO TO 9.

    NO: Replace fuel pump.

  9. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal?

    YES: Replace IPDM E/R.

    NO: Repair or replace harness or connectors.

scientia non olet · About LEMON Manuals