LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (MEXICO) >> Component Diagnosis [For MEXICO] >> P0130 A/F Sensor 1 >> DTC Logic >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 11V at idle. 

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A
    1. Start engine and warm it up to normal operating temperature.
    2. Let it idle for 2 minutes.
    3. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES: GO TO "DIAGNOSIS PROCEDURE ".

    NO-1: With CONSULT-III: GO TO 3.

    NO-2: Without CONSULT-III: GO TO  7.

  3. CHECK AIR FUEL RATIO (A/F) SENSOR 1 FUNCTION
    1. Select "A/F SEN1 (B1)" in "DATA MONITOR" mode with CONSULT-III.
    2. Check "A/F SEN1 (B1)" indication.

    Does the indication fluctuates around 2.2 V?

    YES: GO TO 4.

    NO: GO TO "DIAGNOSIS PROCEDURE ".

  4. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-I
    1. Select "A/F SEN1 (B1) P1276" of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT-III.
    2. Touch "START".
    3. When the following conditions are met, "TESTING" will be displayed on the CONSULT-III screen.
      DTC CONFIRMATION PROCEDURE CONDITION (MALFUNCTION B-I)

      ENG SPEED 1,750 - 2,600 rpm
      VHCL SPEED SE More than 64 km/h (40 mph)
      B/FUEL SCHDL 1.0 - 8.0 msec
      Shift lever D position

      If "TESTING" is not displayed after 20 seconds, retry from step  2.

      CAUTION: Always drive vehicle at a safe speed.

    Is "TESTING" displayed on CONSULT-III screen?

    YES: GO TO 5.

    NO: Check A/F sensor 1 function again. GO TO  3.

  5. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-II

    Release accelerator pedal fully.

    NOTE: Never apply brake during releasing the accelerator pedal.

    Which does "TESTING" change to?

    COMPLETED: GO TO 6.

    OUT OF CONDITION: Retry DTC CONFIRMATION PROCEDURE. GO TO  4.

  6. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B-III

    Touch "SELF-DIAG RESULT"

    Which is displayed on CONSULT-III screen?

    OK: INSPECTION END

    NG: GO TO "DIAGNOSIS PROCEDURE ".

  7. PERFORM COMPONENT FUNCTION CHECK FOR MALFUNCTION B

    Perform Component Function Check. Refer to "COMPONENT FUNCTION CHECK ".

    NOTE: Use component function check to check the overall function of the A/F sensor 1 circuit. During this check, a 1st trip DTC might not be confirmed.

    Is the inspection result normal?

    YES: INSPECTION END

    NO: GO TO "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals